Where there's a Ninja, there's a WAY 😏 You can absolutely press your transfers with a Cricut 👉 but there are a few MAJOR tips to keep in mind💥 👉 Pump UP the pressure: while traditional heat presses give consistent flat pressure, a Cricut heat press can't. We suggest applying heavy to firm pressure evenly across the design. 👉 Temp + Time: Set your Cricut to 320-340°F degrees for 15-20 seconds. If you need more heat, increase by 15 degress and try until you see even application ✅ You can’t over-press your design, so try until you figure out the right settings. 👉 Final Press is KEY: After peeling, place the parchment paper included or a single layer of t-shirt material over the design and press again with the same settings for 20 seconds to soften the design, increase durability, and remove shine. #dtfprint #dtfprinting #dtftransfers #dtf #directtofilm